Problemi con atmel studio 7 e atmel ice

Sezione dedicata al sistema di sviluppo BASCOM-AVR per i micro AVR
At90s, Attiny, Atmega e Xmega

Problemi con atmel studio 7 e atmel ice

Postby santo » 09 Apr 2017, 18:06

Buon pomeriggio a tutti, la scorsa settimana ho acquistato atmel ice per poter programmare tramite atmel studio7, avendo già realizzato un programma con arduino nano e avendo il file hex avevo intenzione di utilizare l'atmel ice per programmare un 328 au, ma non riesco a settare i volt e quindi prima da un errore sui volt ciè che il range va da 1,8 a 5,5 e lui visualizza 0,2v e succesivamente da un errore:
"Failed to enter programming mode. ispEnterProgMode: Error status received: Got 0xc0, expected 0x00 (Command has failed to execute on the tool)

Unable to enter programming mode. Verify device selection, interface settings, target power, security bit, and connections to the target device"
Forse necessita di alimentazione esterna?
Grazie
Santo
santo
 
Posts: 2
Joined: 09 Apr 2017, 17:35

Re: Problemi con atmel studio 7 e atmel ice

Postby js-bascom » 19 May 2017, 07:07

Forse necessita di alimentazione esterna?
SIIIII. Il JTAG non fornisce alimentazione al circuito ma soltanto legge VCC per settare i buffers interni.

Quindi alimenta il tuo circuito DOPO che hai connesso il JTAG, non farlo dopo averlo alimentato o puoi danneggiare il JTAG.

Scusa per l'Italiano strapazzato! :oops:
John Samperi
Ampertronics Pty. Ltd.
www.ampertronics.com.au
* Electronic Design * Custom Products * Contract Assembly
User avatar
js-bascom
 
Posts: 176
Joined: 23 Mar 2013, 02:53
Location: Sydney, AUSTRALIA Ex Nunziata, Mascali (CT)


Return to BASCOM-AVR

Who is online

Users browsing this forum: No registered users and 5 guests

cron